Case-IH® Compatible Standard Rotor Front Impeller Wear Bar Kit

Restore effective crop feeding into the rotor with this quality A&I® aftermarket front impeller wear bar kit. Designed for compatible Case-IH® Axial-Flow combine harvesters fitted with a standard rotor and three-impeller front configuration, this complete kit replaces worn wear bars at the rotor intake.

The front impeller wear bars help grip and move incoming crop material from the transition cone into the rotor. Worn or damaged bars can reduce feeding performance, contribute to uneven crop flow and place additional load on the threshing system. Replacing all three wear bars as a matched set helps restore consistent feeding and dependable rotor performance.

Each hardened wear bar measures approximately 350mm long and incorporates five mounting holes. The kit includes three wear bars and the required mounting hardware for installation.

Case-IH® OEM Cross-Reference

Replaces OEM Part Numbers:

• B94524, A-B94524, 180786C2

Kit Contents

Compatible Case-IH® Combine Harvesters

Features

• Quality A&I® aftermarket replacement kit
• Fits compatible Case-IH® standard rotors
• Designed for the three-impeller rotor front configuration
• Three hardened wear bars supplied as a matched set
• Approximately 350mm long
• Five mounting holes per wear bar
• Mounting bolts, nuts and washers included
• Direct-fit replacement for worn front impeller wear bars

Installation Tip

Confirm that the machine is fitted with the standard rotor and three-impeller front arrangement before ordering. Inspect the impellers and mounting surfaces for cracking, distortion or excessive wear while the existing bars are removed. Replace all three wear bars together to maintain balanced feeding around the rotor intake.

Quality Aftermarket Replacement

This A&I® kit is sourced as a quality aftermarket, direct-fit replacement intended to provide dependable fit, practical service life and good value for routine combine maintenance. Australia-wide shipping is available.