Genuine BYPY® SFT/SO Series Inner Profile Yoke
Restore the operation of your heavy-duty PTO driveline with this genuine BYPY® SFT/SO Series inner profile yoke. Designed for the inner sliding tube of compatible Bondioli & Pavesi® SFT/SO power take-off shafts, it provides the correct fit, strength and durability required for demanding agricultural applications.
This replacement profile yoke is ideal for repairing PTO shafts with a damaged, cracked or excessively worn inner yoke. Its four-tooth profile connects to the inner telescoping tube, while the heavy-duty 42 mm x 130 mm cross kit configuration is designed to suit extra-heavy-duty SFT/SO driveline assemblies.
Using a genuine Bondioli & Pavesi component helps maintain the original driveline dimensions, alignment and operating characteristics, allowing worn components to be replaced without the expense of replacing the entire PTO shaft.
Technical Specifications
- Brand: Genuine BYPY® / Bondioli & Pavesi®
- Component type: Inner profile yoke
- Compatible series: SFT/SO Series
- Tube position: Inner sliding profile tube
- Tube Profile: 4 Tooth 61.7mm x 5.75mm
- Cross kit cap diameter: 42 mm
- Cross kit overall width: 130 mm
- Profile type: SFT/SO four-tooth profile
- Application: Extra-heavy-duty agricultural PTO drivelines
Key Features
- Genuine Bondioli & Pavesi replacement component
- Designed for compatible SFT/SO Series PTO shafts
- Fits the inner telescoping profile tube
- Heavy-duty 42 mm x 130 mm universal joint configuration
- Four-tooth tube profile for reliable torque transmission
- Allows damaged driveline components to be repaired individually
- Helps restore correct PTO shaft alignment and dependable operation
Check Compatibility Before Ordering
PTO shaft components that appear similar may use different tube profiles, universal-joint dimensions or yoke configurations. Before ordering, confirm that your existing driveline uses an SFT/SO four-tooth inner profile and verify the universal-joint dimensions.
- Measure one bearing cap diameter: 42 mm
- Measure the complete cross kit width: 130 mm
- Confirm the yoke fits the inner sliding tube
- Check that the tube has the matching four-tooth profile
- Compare the original yoke and driveline identification before installation
The C&M Difference
Collier & Miller supplies genuine PTO driveline components backed by practical agricultural parts knowledge. Our experienced team can help identify the correct replacement yoke by checking the cross kit dimensions, tube profile and driveline series, helping you minimise downtime and avoid ordering the wrong component.
Expert Maintenance Review
When replacing an inner profile yoke, inspect the complete PTO shaft assembly rather than just the damaged component. Check the universal-joint cross kit, bearing caps, telescoping tubes, retaining hardware and safety guarding for signs of wear, distortion or cracking. Ensure the sliding profiles move freely without excessive backlash or binding.
Replacing worn universal joints or damaged telescoping tubes at the same time as the yoke will help maximise the service life of the repaired driveline and maintain smooth PTO operation.
Installation Tip
Before carrying out repairs, shut down the tractor and implement, remove the ignition key and ensure the PTO driveline cannot rotate. Mark the orientation of the original yoke before removal and use suitable workshop equipment when installing the universal-joint bearing caps.
After assembly, verify that all retaining components are fully seated, the universal joint articulates freely and the telescoping shaft slides smoothly throughout its operating range. Always refit all PTO guards and shields before returning the machine to service. Never operate a PTO shaft with damaged or missing safety guarding.